PBME ITM screen keeps changing torque key message

As the subject implies, the Porsche Button Module Endurance screen, whether at legacy or any of the telemetry screen, after performing a right turn, upon straightening (wheel turns left back to center), the ITM screen changes to the torque key message, same message when the wheel base is first turned on.

Running driver v400.

Windows 10 64bit.

Had a tough time flashing the PBME firmware because it keeps failing, got lucky only to encounter this issue. Not looking to spend few days again to reflash, if there is another possibility to correct the issue .

Did reflash the base & motor to no avail.

Nothing wrong with the screen, just the normal flickering.


Sign In or Register to comment.