Fanalab ITM Setting on Base and Button Module
I cannot set the ITM to display on the Button Module, it works fine on the DD1 Base. Also is it possible to view different pages of the ITM on the Base and the Module ?
Thank you
I cannot set the ITM to display on the Button Module, it works fine on the DD1 Base. Also is it possible to view different pages of the ITM on the Base and the Module ?
Thank you
Comments
Did you TURN the funky switch while pressing the TM button? And yes you can display different pages on each display.
Thank you
It's worth noting that you will likely run into issues if you display ITM on the Base - Fanatec know that it causes 'knocks' in the FFB. It has been like this across all drivers since launch and still no ETA for a fix.
I would like to add that it would be cool if we could remap the button to change the display. Its difficult while driving. But thanks for the cool products!
I posed this question in the fanalab forum yesterday and was told that would not be happening.
Yeah i was feeling some odd knocks from time to time
I would also like to have the wheelbase show a different screen to the ITM screen on the Porsche wheel but am having an issue in AMS2 that every time I start a new lap the wheelbase screen changes to what is displayed on my wheels screen.
Is this a known issue or have I missed something in the setup?
you may need to disable the automatic page switch feature in FanaLab for the DD OLED.
Thanks for the reply Maurice, I am away from my PC at the moment, is that I the ITM page? Can't recall seeing it.
Oh I see, I found it, is not really obvious. Is clever though.