CSL brake pedal is not calibrated
Javier Blanco González
Member
in Pedals
I have CSL pedals, when I push brake pedal to 100%, the software goes only to 60%.
CSL DD
Formula v2.5
CSL pedals
drivers in the image
Do you know how to solve it?
Thanks a lot
Comments
Section 6.4 of the manual explains how to calibrate the pedal. Basically you have to go into manual calibration mode and then set a max and min for the brake, for reference https://fanatec.com/media/pdf/4f/6a/97/CSL-EP-LCK-ManualPBzGoX5iIGFvH.pdf
If you have the CSL Pedals two-pedal set, manual calibration is not available. This is only possible through the upgraded electronics of the Load Cell Kit.
Javier, it looks like your wheel base firmware is up to date, so it should auto-calibrate correctly. You should open a support ticket via the My Products section of your Fanatec account to get this resolved.
[Fanatec Community Manager]