CSL Pedals seen as Shifter...

Paul VelascoPaul Velasco Member
in Pedals

When I plug in the CSL Elite Pedals my PC is seeing it as the Shifter.


fanatec.jpg

Suggestions to resolve this please?

Cheers

PV

Comments

  • Maurice BöschenMaurice Böschen Member
    https://www.youtube.com/watch?v=X-7oax-pNPk


    Watch that video. You have to flash the correct firmware to the USB adapter, in this case CSL Elite Pedal Mode.

  • Paul VelascoPaul Velasco Member
    edited May 2020

    Thanks for the reply

    Time is not on my side but finally got to doing what you said. The problem persists

    My wheel drives for about a minute then suddenly force turns off, pedals stop, wheel does not turn and lghts flashing

    So with regards to your explanayion, I see this in my Controllers (not what is shows on your video):

    1-fan1.jpg

    Please note: I have no clue why there are two Fanatec wheels detected by the controller, but for what it is worth before this problem happened there was only one controller showing

    I am almost certain prior to the failures there was only one controller showing.

    In this screen all the axis are working and everything seems fine:

    2-fan2.jpg

    To update drivers - no need apparently:

    1-fan4.jpg

    When the wheel cuts out this is what the control panel looks like:

    1-fan5.jpg


    Please advise

    Cheers

    PV

  • Paul VelascoPaul Velasco Member
    edited May 2020

    After another day of testing:

    Took of the loadcell brake pedal, and sparated the wheel and brake into two separate USB ports

    1-fan9a.jpg

    Drive for about ten minutes and wheel 'switches off' but current still flowing because lights are flashing. Pedals working but wheel goes dead and disappears off Game Controller panel.

    The problem appears to be with the wheel and/or base...

    Ideas to sort this out?

    Cheers

    PV

  • Paul VelascoPaul Velasco Member

    Any feedback?

Sign In or Register to comment.