DD2 Power Supply Extension Cable
Robert Mezzone
Member
I have a P1-X and a DD2 and I'd like to mount the brick under the pedals, however the power cable that runs from the brick to the back of the DD2 is a few inches short. Is it possible to extend this cable. It seems to be a 6 PIN PCI-e connector, not sure about the specs of the wire. Can't find much on the Internets. Any assistance is appreciated.
Robert
Comments
Guess I could make my own, only need it to be about a foot long. Does anyone happen to know the gauge of the wire.
These should work
https://www.amazon.com/gp/product/B075R34LJ4/ref=crt_ewc_img_huc_1?ie=UTF8&psc=1&smid=A3M6TV4DFEXUV8
Doesn't matter. The plug that you linked only accepts 14-20awg. Even 14awg, the lowest you can use can handle 15 amps easily which is plenty for the wheel base.
After posting the message I found a way to route the power cord allowing me to mount the power supply under the pedals, much to my surprise I've been able to hide all the wires. Thanks for the response.