Problems mapping wheel after updating drivers and firmware
Stephen Goen
Member
Last night I found through fanlab that my cls motor , wheel and pedals had a firmware update. After updating I went into Iracing and had to configure my wheel. As I was going through the configuration process, my clutch was not recognized. Then as I started to map the paddle shifted and other buttons, I kept getting Dev 0 Btn 8. This started to happen on all the buttons. So far I have uninstalled drivers and installed older drivers. Still no help. If I hold down a button and click done, sometimes that will work to map that button. I still have no clutch. If I go into the fanlab everything show's up and works, just not in the Iracing game. I don't know if this is and Iracing problem or a Fanatec problem.
PC drivers 402
Wheel Base Firmware: 684
Wheel Base Motor firmware: 22
Any ideas that I can do get this working again.
Comments
Please downgrade to driver 381 again, as driver 402 causes sensitive issues with your wheelbase.
Please try mapping the buttons again after that.
I uninstalled the 402 drivers and install the 381 drivers. That took care of most of the problems. My only problem now is I dont have a clutch in Iracing. The c;ucth does show up and work in fanatec wheel property page. Any ideas?
did you calibrate the clutch pedal + manual clutch enabled?
I did not, but made the change and everyting is working now. Thanks
Does anyone know if this update ahs helped with the notchiness in the CSW 2.5?
notchiness depends on the motor firmware version you are using.