Pedal v3 firmware stuck in v1.30

Bernard ChevalierBernard Chevalier Member
in Pedals

Hello, I am not able to update firmware to v1.32 even by rebooting/disconnecting usb/repairing pc driver 429 with pedal directly connected to usb pc (and without rj12 connected to wheel base), still looping in 1.30 :-(

any clue ?

thanks

Comments

  • nin channin chan Member
    edited June 2022

    Same here, but finally got it fixed.

    When trying to launch "fwpedalupdater.exe" in the folder fanatec/fw/ manually, it said missing vcruntime140.dll and msvcp140.dll. These two are Visual C++ files.

    Then I installed back Visual C++ Redistributables. https://docs.microsoft.com/en-us/cpp/windows/latest-supported-vc-redist

    Not sure which versions are a must since I had tried to install all x64 with no luck. Then i got the updater successfully ran after installing 2015-2022 x86. So, i guess probably "Visual Studio 2015, 2017, 2019, 2022" x86 version, maybe x64 necessary as well.

    If the updater successfully run, then just close it and update the firmware as usual with Fanatec Control Panel.

    Good luck mate. Hope it helps.

  • nin channin chan Member
    edited June 2022

    .

Sign In or Register to comment.