[Resolved] DD1 sending signal to Meca cup1 throttle and clutch

Quentis GillispieQuentis Gillispie Member
edited March 2022 in Wheel Bases (and Racing Wheels)

Hi all,

I DD1 (1 week) is triggering the throttle and clutch on my meca cup1 pedal whenever turn the wheel on multiple sims. The DD1 on firmware 691 and the PC driver is 439 I've tried manually assigning controls again reinstalling the driver. Any help?

Comments

  • Maurice BöschenMaurice Böschen Member

    Is your Rig grounded properly?

  • Quentis GillispieQuentis Gillispie Member

    Good question. All of the power connections are connected grounded outlets.

  • Quentis GillispieQuentis Gillispie Member

    I think its fixed now. even with the DD1's USB cable disconnected the pedals would pick a signal from the wheel. Seems the pedals just needed to be recalibrated and the issue is fixed.

  • Quentis GillispieQuentis Gillispie Member

    Still not working after recalibrating the pedals. When I turn the wheel I get like 5% throttle and clutch

  • Quentis GillispieQuentis Gillispie Member

    seems i might need to ground the pedal controller electronics.

  • Quentis GillispieQuentis Gillispie Member

    connected a wire from the USB B connector in the pedal electronics to the pedals base plate which is grounded to the cockpit. Issue fixed

Sign In or Register to comment.