Shifter seems to be stuck in sequential mode
Merritt Cely
Member
My shifter seems to be stuck in sequential mode. Even though I have the switch on the H-formation, it behaves in-game as sequential. I also only see sequential in the Fanatec control panel when I connect the wheel base to my PC. When I try to calibrate the shifter using the wheel, it flashes "Gear N" on the OLED panel for a second but then goes away. I have tried some things I’ve found online like unmounting the shifter from the stand and attempting to calibrate in my lap, but no luck. Any ideas?
Comments
Which driver and which Base are you using?
Hardware: Gran Turismo DD Pro with boost kit and load cell pedal
Stand: Next Level Wheel Stand 2.0
Fanatec Driver: 439
Pedal Firmware: 1.6
Wheel Base Firmware: 1.1.5.4
Wheel Firmware: 7
I've tried reinstalling the firmware and the fanatic driver with no luck either.
Well while I waiting on Fanatec support I decided to open up the top and take a peak inside. It turns out that the little red and black wire that runs from the bottom of the unit was unplugged from the circuit board at the top, lol. I plugged it in and the h-pattern works now.