CSL brake pedal LC manual brake calibration problem
Raul Vallespin
Member
in Pedals
Hi!.
I just got the CSL pedals with LC. The issue so far is when a try to set BFR under 70% the break pedal stops working, with any given value between 70% to 100% works just fine.
Even with no input at all, Fanatec Control Panel sets the brake to 100% as soon a reach 60% on the slider, and the pedal just die.
This is exactly the same problem:
https://www.youtube.com/watch?v=OS2D7fYnCsA
Any help? Thanks!
Comments
Hi Raul,
Have you tried switching between auto and manual calibration and setting a new Min value for the brake axis? It is important to rest your foot slightly on the pedal while you click 'Min', in order to establish a clear starting point that is away from the 'true' zero.
If you are already in manual mode, you can try switching back to auto - the reset could also help to fix this.
If this doesn't help, then please open a support ticket via the My Products section of your Fanatec account, and the team will help you further.
[Fanatec Community Manager]