No response on calibration screen when I press the brake pedal
Hello,
When I go into the Fanatec Control Panel, and select Pedal via Base, I get the normal response when I press either the throttle or the clutch (the status bars go from 0% to 100%), but when I press the brake pedal, I get no response. When I play a sim game, the brakes don't work, either. The brake calibration was working fine in the past, so this is a new problem. Any suggestions? I hope I don't have a bad pedal assembly... Thanks.
Comments
You should contact the support as the Brake is dead
Noooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooo!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
That's what I was afraid you'd say. What kind of turnaround should I expect for an issue like this? From the comments I'm reading, the response from Fanatec support is pretty dismal. Has anyone had any more positive experiences recently?
Get it fixed?
Mine failed also. I hope they fault it for you. I had no such luck and they were sent back after being without them for at least a few weeks (including posting times). The problem was not diagnosed by FANATEC.
I was very lucky to have a good friend who is an electrical technician fix it. He found a failed voltage regulator within the control unit mounted to the brake pedal. Finally back on track.