Throttle Mods for CSL LC Pedals?

Mark LynnMark Lynn Member
in Pedals

Hi, I've been using my pedals for over a week now and would like a little bit less travel on the throttle. I've no complaints about the pedals at all, they're fine and I'm enjoying using them, I just prefer a little bit less throttle travel as it's what I'm used to.


This from 3DRap would be ideal but it's too pricey for what it is, especially with shipping on top. I was wondering if anyone had done something similar just using cheap easy-to-find materials. Or by adding something to make the diameter of the built-in pedal stop bigger?

Comments

  • Gagaryn .Gagaryn . Member

    Buy Spacers - Accu

  • Mark LynnMark Lynn Member

    Thanks, I'm looking into it. It's difficult to judge sizes etc, was hoping someone had already tried something and had some dimensions.

  • Stephen JayStephen Jay Member

    Maybe remove one of the polymers, measure it then replace with the equivalent sized washers?

  • Mark LynnMark Lynn Member

    That's what I ended up doing, still sort of guessing at the size of washers though because they need to be bigger than the existing stop (which is 12mm diameter in case anyone else is interested). I ordered some cheap nylon washers so I'll just try them out when they arrive.

  • Paul MaherPaul Maher Member

    these can be used add adjustable tension to the throttle or clutch (non load cell brake) pedal, IMO the throttle pedal is way too light

    https://www.ebay.co.uk/itm/185672420193

Sign In or Register to comment.