ClubSport Steering Wheel F1® Esports V2
Dalibor Milivojša
Member
Does this wheel suport high torque mode on DD1/DD2?
If it does why do i get the message "Torque is reduced to prevent damage on the simplified quick-release system"? I have QR1 on it. And i get asked to enable torque, but when i press ok button nothing happens.
Comments
Yes.
Could be that the detection pin is somehow pressed. Detach the QR and push on the little plate a few times with some Tool and then attach the QR again and check if High Torque works now.
Also make sure that you are on driver 450.
I have another wheel with podium hub and it works fine. Updated to all new drivers PC DRIVER 450, Wheel Base 3.0.1.4, Wheel Base Motor 3.0.0.2.. I have removed QR and pushed that metal plate few times but still the same problem. Wheel is new bought it few days aggo.
I did it, i had to pull it towards me to hear the click...
Ok it it switches back again on its own... obviusly theres a problem with the switch. What should i do?
contact the support.
Remove the small lower back cover and checked that the white wire is not pressing on the switch.
Thank you Hristo. :)