No gear paddle change/ lights on new-ish CSL P1 V2
Richard Hough
Member
Recently bought a DD 8nm, V3 pedals as well as CSL PI V2. And very happy I am too with it all…except…
yesterday I noticed after a lap, I could no longer change paddle gears. (Content Manager)
I also tried this in AMS2, also could not select gears. I also notice no lights or buttons work either on the wheel.
I have the latest firmware as I checked, I have removed and replaced the wheel, no pins damaged, plus re downloaded the 450 driver, as my wheelbase was not responding after I had tried a few fixes ( the power light was dim and slowly flashing) . Also I unplugged the devices and plugged in again.
I can race with auto gearbox, not very satisfactory!
Any suggestions what to do?
many thanks Richard
Comments
Try this:
I can see a gap! Hope this works, many thanks!
All fixed….many thanks for your help!
Make sure the clamp bolt is very tight, the recommended torque is 15Nm.🙂
I have done it “ hand tight”, very hand tight