Handbrake input no longer recognized after 1.10 firmware update
David Beem
Member
Like title says, I updated firmware and the Fanatec Control Panel no longer recognizes input from the handbrake. The control panel shows the handbrake, shows the max/min calibration option, but the meter which normally registers calibration input no longer shows me pulling the handbrake. Any ideas? I've tried using the USB adapter, and plugging into the DD Pro wheelbase directly. When plugged into wheelbase, Fanatec Control Panel doesn't recognize it at all. When plugged into usb, it recognizes device, (shows picture) but doesn't recognize device input. Incidentally, Fanalab no longer recognizes the device is connected.
Comments
Hello David! Have you solved your issues?
I upgraded to PC Driver 455 and now Fanatec Control Panel no longer recognizes input from the handbrake. My handbrake are connected to CSL DD 8 NM. The handbrake Calibration max/min buttons option are available but the meter don't show any input.
Frustrating that a driver update kill your gear!
Did you get it working again? I just plugged my handbrake back in after finding space for it again after some flight sim upgrades necessitated taking it off, and now it just acts as if it's not even there. Plugged directly into my DD1. I was on driver 456 with all firmwares updated, reverted driver only to 455 (official) with no difference. Thanks.