DD PRO 8nm failure on LMU

Anthony DUROAnthony DURO Member
in Other Racing Games

Hi !

I'm experiencing an issue with their Fanatec DD Pro 8Nm wheel and V2.5 in LMU.

Specifics:

* Trigger: The problem occurs intermittently, mainly during online races, after heavy braking.

* Effect: The wheel locks up and spins to its maximum extent in one direction or the other.

* FFB Loss: The force feedback (FFB) is lost after the wheel locks up.

* Solution: I need to restart the entire game to get the FFB working again.

* Frequency: This issue happened 4 or 5 times in one day, causing frustration.

Additional Information:

* Software: I use Fanalab software to configure their wheel.

* Profile: I use Maurice's profiles.



Sorry if I've posted into the wrong section. I will move the topic if necessary

Comments

  • Vladimir KovalVladimir Koval Member
    edited February 15

    Before starting the game, start "fanatec control center", check the wheel and pedals settings in the control center - Run any tests on your wheel and pedals within control center - shaking / forcing of the wheel. Push the pedals all the way down and also turn the steering wheel all the way left and right. This will cause the software driver to register the correct limiting values.

    Then close / end any fanatec settings / control center software. Or you may leave it open but don't change here the settings while the game is runnig too.

    Only now, start the game.

    Don't configure the wheel and pedals in "fanatec control center" while running the game at the same time. Otherwise they may interfere with each other and fight for the control of the wheel and pedals.

Sign In or Register to comment.