Wheel suddenly not being detected
I have the McLaren gt3 wheel with the CSL Dd base 8nm on the qr1 lite for a little over a year with no issues. Recently I started haven’t disconnect issues and it appeared it was a loose shaft connection so after tightening the clamp multiple times with some limited success I decided to bite the bullet and get the QR2. Now I can’t get the wheel to show connected at all. I believe I installed everything correctly and payed careful attention to the correct screws to be used based on my wheel but I haven’t been able to figure this one out. And help would be greatly appreciated as this is extremely frustrating.
Comments
Disregard. Problem solved.