ADVANCED PADDLE MODULE ISSUE

Andrea BeccaficoAndrea Beccafico Member
in Fanatec Other

Hi guys,

yesterday I installed on my formula v2.5 x the advanced paddle module.

I had a hard time disconnecting the old paddles and connecting the new ones. the plugs you have to detach / attach seem not to fit properly .. have you also encountered this problem? I am attaching photos to make you understand what I am talking about.

(the photo is taken from the internet, I also noticed that my connectors are covered with some sort of yellow color gel)

HOBOML19KQOW.jpg


Comments

  • OhthreeemthreeOhthreeemthree Member

    I did not have any issues installing them on my BMW GT2 V2, but sadly remapping buttons is not supported by GT7. Which is what i was hoping for. :(

    Mine did not have any gel/glue, but i was very careful to pull then straight up. Also I think my wheel has better access to those.

    If you aren't having any issues or bent pins you should be good to go.

  • Dominic BrennanDominic Brennan Member, Administrator
    https://forum.fanatec.com/discussion/25422/advanced-paddle-module-issue

    Hi Andrea,

    If you're having installation problems, please open a support ticket via the My Products section of your Fanatec account.


    [Fanatec Community Manager]

Sign In or Register to comment.