Fanatec DD2 starts up and the wheel won't turn

Today I turned on the DD2 and the FFB is unbearable. It's incredibly hard to turn the wheel and now I can't even see the wheel on the property page.

I tried upgrading to the latest beta firmware also - and I can't see anything now. What do I do?


  • Joseph GossenJoseph Gossen Member, Moderator

    Are you able to access the on wheel ffb settings ?

  • edited November 2019

    I found out the issue - i switched USB Ports, but since I updated I have a new issue where Fanalab's SEN Rotation value says 900 but on the wheel base it turns into 2170. It doesnt match what fanalab says. I cant even get to 900 degrees if fanalab is on, because 2170 on the wheel base is 900 rotation in the fanalab software, but if you go down on the wheel base, fanalabs wont let it get to 900 on the wheel base, it doesnt let it go that low. If I turn of Fanalab, it works fine and I can set it back to 900 degrees.

    Any ideas?

Sign In or Register to comment.