How to install a new PCBA main board on Club Sport V3 Pedals (inverted if it matters)??

W Ross Cardon IIW Ross Cardon II Member
in Pedals

So during a lovely Firmware Update, my PCBA main board shorted out. I purchased a new board from Fanatec... but they didn't include any instructions.

I figured it couldn't be too hard... but access to that circuit board is odd.

Anyone have any guides/suggestions/videos on how to install a new PCBA main board on Club Sport V3 Pedals (inverted if it matters)??

Comments

  • Remco Van DijkRemco Van Dijk Member
    edited October 2020

    The CS Handbrake Quickguide shows how to access the circuit board on a V2 set by removing the circuit board base plate from the pedals, it's very similar on a V3: https://fanatec.com/media/pdf/88/5d/92/CS-Handbrake-QGlVFnrGyuuJCfV.pdf

    The extra step would then be to remove the board from the base plate by removing the four screws holding it in place. Don't forget to put back the plastic washers when mounting the new board on the base plate.

Sign In or Register to comment.