Replacing brake rumble motor v3
Ian Gibson
Member
in Pedals
I have had a replacement rumble motor for my brake waiting to install for a while now.
I tried to do this yesterday but was unable to pass the white plug between the brake lever and the bar the lever pivots on. It is wider than that gap. The original motor wire is routed through here and I can't remove the old wire (unless I cut the plug off) and will not be able to route the new wire through here.
Is there a way to do this without changing the routing of the wire? .
Or do I have to disassemble the whole pedal assembly to get the wire through that gap?
Comments
<tumbleweed>
Just replaced brake pedal rumble motor (thanks for Fanatec support!).
Had to take pedal off from it axles, removed clutch pedal first and so on.
Sadly it didn´t work, still can´t feel anything with sol, however motor seems to work just like previous one.
I wonder if rumble is decreased with latest fw for V3 pedals ??!!??