Pedal adjustment
Arnt Kenneth Wik
Member
Hy guys
I have a 6 mnd old Fanatec setup, a DD1 with the V3 pedals connected to the base.
A few days ago I noticed that my break pedal stated to display a small input In Iracing, when I rest my foot on it.
But when I went in to the controller software to adjust the dead sone, that was not possible??
There is no set min/max buttons under the pedals, only a test rumble option. (The pedal rumble have not worked in months either, but don't really care about that).
My question is, how do I adjust the dead sone when that option is gone? I have the latest software.
Do I need to plug the pedals directly to the PC, and not the wheel-base?
Hope someone can help
Ps. I also want a bit stiffer throttle pedal, and the pedals came with a extra spring….Will this spring make my gas pedal a bit stiffer then the red one thats on it? Or is it the same?
Cheers Kenneth
Comments
The checkbox to enable manual calibration is on one of the other tabs. Uncheck it there and then go back where the bars a shown to calibrate deadzones.
Thanks mate :)