CSL Elite Pedals (Non-Load Cell) 100% Brake Point Always Resets

Hi there,


Apologies if this has been covered but I couldn't seem to find it while searching. I might also just not be doing something right. But everytime I use the turn on the wheel and use the pedals, the calibration is reset. As in, when I load up GT Sport on PS4, or Assetto Corsa on PC, any pressure immediately hits 100% brake. Then the harder I press it, the further the travel to reach 100%. Is this a setup issue somewhere? It's really tough to be consistent when everytime I push the brake, 100% brake is different. Hopefully I'm explaining this well.


Thank you in advance for any help!

Comments

  • Sounds like you have automatic calibration enabled on the pedals. Then the 100% only works normal after boot and you fully press the pedal for a first time.

    If the first pedal press you only press 20% the calibration thinks that is 100% pedal travel and it will change once you press each time a bit further.

    You can enable manual calibration in the driver and then do a manual calibration and after it will be always the same.

  • Thank you very much!

Sign In or Register to comment.