Fanatec Driver 415 for CSL, CSW and Podium WB (all wheels)



  • Hey,

    i hope there will be a chance to higher the ffb for the csl dd up to 200 % at the next driver update, to solve the problem with acc on xbox. (I know that are only a very small target group). :-(

    Kunos isn't doing anything about it.

    Best regards


  • Marcel PfisterMarcel Pfister Member, Administrator

    New driver 423 available:

    Please continue the discussion in the new thread, this one will be closed.


    New driver UI

    • Now supports also the following bases: ClubSport Wheel Base, ClubSport Wheel Base V2, ClubSport Wheel Base V2.5, CSL Elite WB + (PS4), CSL Elite WB, CSL Elite WB 1.1
    • Fixed issue of shifter tab showing input indicators when pressing buttons on a wheel.
    • Fixed freezing when collecting logs from the "No Device Found" page.
    • Fixed crash when changing base modes while UI is open.
    • Fixed issue where window of the new UI was stuck minimized and couldn't get opened.
    • Re-located where "New Firmware Available" label is shown.
    • "New Firmware Available" label is clickable and opens the Firmware update page.
    • Improved discrepancy between clutch axis value in driver UI and Clutch Bite Point value shown on wheel.
    • Added support for ClubSport Universal Hub V2 (for Xbox).

    Firmware Manager

    • Fixed issue of CSP V3 not updatable if USB-adater is attached at the same time.
    • Fixed "Failed to load default firmware file [-4]" when user name has diacritical marks e.g. Š,, Ł ä, ö, etc.

    Firmware Overall

    • Added support for ClubSport Universal Hub V2 and ClubSport Universal Hub V2 for Xbox.
    • Fixed issue where values on the display stopped showing after Clutch Bite Point value was shown.

    CSL DD

    • Fixed issue where BMW GT2 funky switch had ghost inputs to all other buttons.

    Podium DD

    • Fixed rare issue of specific bases where wheel center position would suddenly jump 360° to a side causing the wheel to rotate to the new center position.
    • Optimizations in communication between base and motor firmware.


    • Enabled more colors for rev-stripe

This discussion has been closed.