Cannot Connect V3 Pedals to CSW2.5
Chris Grandell
Member
in Pedals
I have a set of V3 Pedals and a CSW 2.5 that I bought used from a friend. The pedals work fine if connected via USB, but I cannot get the wheelbase to recognize them if connected with an RJ12 cable. I don't have the original cable, so I have tried a couple of phone cables I have, but they aren't working. The cables have four conductors, so I think that is the right cable.
I have updated the firmware of both the pedals and the wheelbase/hub. Hasn't helped any. In the driver software this is the screen I see:
I am confused about why the shifter shows up, as I do not have a shifter yet. I believe the pedals are plugged into the right port on the wheel-base, and have checked that.
Any other trouble-shooting I should try?
Thank you!
Chris
Comments
If your cord only has 4 conductors, you likely have an RJ-11.
You need an RJ-12, which uses six.
Thank you! Will have to see if I can find one. I appreciate it!
Make sure you get a straight through RJ12 cable rather than a reverse wired (crossover) cable. And buy a decent quality shielded one.
Thanks! Amazon delivered today. Working great.
Now need to fix my handbrake. Pretty sure the connections from the sensor to the Jack are messed up.
The wiring is green to tip, red to ring and white to sleeve. Once you strip back the black heat shrink you'll see the coloured wires.