Fanatec DD1 360° calibration after start

Fabian MenkeFabian Menke Member
in Wheel Bases (and Racing Wheels)

Hello,

I noticed a while ago, that the DD1 wheelbase turns the wheel 360° to the right after the start. It´s always the same direction. I am pretty sure, that it was earlier a bit to the left and a bit to the right and then was the calibration finished.

So I am little bit confused, why this calibration behavior changed and could this cause problems with the wiring in the wheelbase (the connector to the wheel) ? I mean, when I would 1000x turn off and on the wheelbase, it would 1000x turn to the right ?!?!?!

Comments

  • Maurice BöschenMaurice Böschen Member

    That's perfectly fine.

    Some bases turn 40 degrees to the right and then back to center, some do a full Rotation. Has something to do with where the positional sensor is placed in Relation to the QR placement.

    Both is fine.

  • Fabian MenkeFabian Menke Member

    ok thanks

Sign In or Register to comment.