Impossible to go through Motor Calibration during firmware update

Hello gents,

I’m currently using a Podium Racing Wheel F1 with V3 pedals, so I have the F1 Wheel connected on it.

I’ve got an issue today while wanted to update my steering wheel base through the Firmware Manager. Basically all was fine until the motor sensor calibration process.

I’m stuck there, and even after removing my steering wheel, it is still detected (I can see the logo on my dash), so I cannot go through. When I try to replug it, and go in tuning menu, it’s of course impossible. Even on Fanatec Property Wheel, I cannot test my steering wheel.

I’m afraid to close everything and restart (don’t know how much it could damage the update process), so has anyone a solution to this issue?

Thanks a lot.

Sign In or Register to comment.