F1 22 (Xbox) - Fanatec Recommended Settings
![Dominic Brennan](https://forum.fanatec.com/uploads/userpics/174/n70FVJFNOWNG0.jpg)
in F1 20xx
General Notes:
- The settings below are considered to be reasonable baseline values for F1 22 (Xbox). They might not suit all tastes and driving styles, but they are a good starting point.
- In order to apply the suggested settings correctly, it is important to assign both the Tuning Menu values AND the suggested In-Game settings together.
- These settings assume you have updated all firmware from the latest Fanatec Driver package (available on the front page of the Fanatec website).
- If you cannot access all the settings shown below, you are probably in the Standard Tuning Menu. To switch to the Advanced Tuning Menu, first enter the menu (short-press the Tuning button once), then press and hold the Tuning button for about four seconds.
- You may see additional Tuning Menu settings depending on your connected devices. These additional settings are not relevant to force feedback, and are not listed here.
- The settings for the CSL DD / Gran Turismo DD Pro are suitable for 5 Nm and 8 Nm (Boost Kit 180).
- The settings for the Podium Wheel Bases assume you are in High Torque Mode. In Low Torque Mode, the same settings can be used, but with a higher FF value.
CSL DD / Gran Turismo DD Pro
Tuning Menu Settings:
- SEN 2520
- FF 100
- FFS Peak
- NDP 50
- NFR 20
- NIN Off
- INT 3
- FEI 100
In-Game Settings:
- Vibration and Force Feedback: On
- Vibration & Force Feedback Strength: 70
- On Track Effects: 10
- Rumble Strip Effects: 20
- Off Track Effects 20
- Wheel Damper: Off
- Understeer Enhance: Off
- Maximum Rotation (F1 & F2): 360
- Maximum Rotation (Supercars): 900
Podium Wheel Base DD1 / DD2 / Podium Racing Wheel F1
- SEN 2520
- FF 45
- FFS Peak
- NDP 30
- NFR 5
- NIN Off
- INT 3
- FEI 100
In-Game Settings:
- Vibration and Force Feedback: On
- Vibration & Force Feedback Strength: 60
- On Track Effects: 10
- Rumble Strip Effects: 25
- Off Track Effects 25
- Wheel Damper: Off
- Understeer Enhance: Off
- Maximum Rotation (F1 & F2): 360
- Maximum Rotation (Supercars): 900
Comments
I tried these settings on Xbox Series S and they work fine, I would recommend to use them as starting point and then tweak little things if necessary.
I have only one problem with using CSL DD on F1 22, after entering pause menu or starting practice/qualifying/race there is a delay around 1 sec long where you don't feel FFB on the wheel. And that can cause mistakes and possible crashes until you feel the FFB. Is there a way this can be fixed?
This configuration no longer works after the latest firmware
*dd pro