V3 Pedals Clutch will not set minimum when connect to CSW 2.5, but ok on usb port

I have the V3 Pedals. if i connect them to my CSW 2.5 , the clutch remains at a min value of 50%. i cannot set it with the manual calibration to zero. also tried via the wheel, when in setup, left+right paddle + d pad down.


if i connect the pedals direct to a usb port then all is good , the clutch reads zero, but the i loose the BRF function on the brake.


anyone any clues.


i have the beta drivers 365 installed.

Regards

Comments

Sign In or Register to comment.