My DD1 from control panel says this:
(indeed when torque key is inserted)
Does it the expected value?
The control panel shows the max torque available dependent on the force set in the loaded profile. So assuming the DD1 is 20 N m at 100 guess you have the force set to 67 or 68?
Actually the FFB was set to 90%, when set to 100% value is now:
I guess this is the correct value as this value is not the peak but just the max.
Thanks for your comment.
15 Nm is the max value when you have set FFS to LINEAR instead of PEAK.
I got the full answer, thanks a lot!