ClubSport Pedals V3 inverted not work on xbox series x!!
Krzysztof Bąk
Member
Witam mam problem polegający na tym że moje pedały ClubSport Pedals V3 inverted przestały działać na konsoli xbox series x po zainsalowaniu aktualizacji 454 a na poprzedniej aktualizacji raz działały a raz nie, ale teraz już w ogóle nie działają. Jak wejdę w panel fanatec na komputerze to wszystko jest ok ale po odłaczeniu i podłaczeniu do konsoli juz nie działa.
czy ktoś ma tak samo i wie jak to naprawić?
chociaż żebym wiedział że nie jestem sam :)
z góry dziekuje za pomoc
Comments
If it was intermittent before, it could be your RJ12 cable or it could be a grounding issue. It's hard to know. I would revert to your last driver where they worked intermittently and see if they still do first.
Dziękuje za rade właśnie tak zrobiłem wracając do poprzedniej aktualizacji już jest ok :)
Please post in English according to the forum rules.
Think driver 454 Is causing some folks some issues with pedals etc not working after the update.
you should not use the 453, it have huge issue with games, better use 452 instead then
You're right it happened again and I can't deal with it anymore and it's only a new piece of equipment because I bought it last week and with it such problems all the time :( and I was just about to change to the 452 update because as I looked at it is probably the best solution, therefore, because I bought for it also a steering wheel formula v2 and when I connect it all resets and I can no longer play.
I will try to update to 452 and let you know how it went
nothing has changed it is still the same everything works just not the pedals. i don't know how to connect them correctly to make them work because it takes a lot of time before they work and then i don't know how i did it :(
EVERYTHING IS WORKING it's because I had the pedals connected to both things at the same time but luckily I didn't damage anything I disconnected it from the usb port and it's only connected to the base and everything worked right away :)
good, but yes you should not connect both cables at same time.
I've been like this for almost a week and after many attempts something clicked but now it's sure that it was the fault of connecting two inputs but there is still a problem with the formula v2 steering wheel because after connecting any steering wheel the base goes into clubsport mode but after that you can't connect the other one and you have to turn off the base, remove the steering wheel and put the other one in and then fire it up
could be delay issue. but not sure 100%
there is indeed this kind problem, but it not happens always
Maybe in time it will fix itself :) but the most important thing is that I can at any time unplug the pedals, set them as I want in the fanatec panel and plug them back in without stressing about something going wrong.
and thanks for your help Allan Lehtla :)