Clubsport wheel base v2.5 (HELP)
Resently updated my drivers and firmware and since then i have zero forcefeed back. I press the Force Feedback test and the wheel moves with no torque. zero resistance . How can i go back to previous firmware as i believe this to be the problem? i can only see previous driver downloads.. Hope someone can help it was work brilliant before firmware update.
Comments
You can roll back Firmware via the UI.
Be sure to follow all directions as if not followed properly can cause bigger problems.
Before you do that I would suggest uninstalling the Fanatec Driver package/Reboot/Install. I have used this process whenever there is an update as I have had similar issues as you have described in the past.
Good luck.
Thanks but i dont see any downgrade firmware option via uI in the Fanatec firmware manager
Is there any Fanatec support here? really need to get this problem sorted
Unfortunately I sold my CSW v2.5 and am awaiting the CS DD so I am unable access the area of the UI I need to give detailed directions.
Perhaps @Maurice Böschen can provide some assistance, but I think you have to tick the box about manual update of firmware and then prompts from there??
Thanks,appreciate your time. but the new updates and firmware are definatly not good for the CSW V2.5 . Be warned CSW users I will revert to older drivers and somehow the old firmware if i can figure how to revert them back .. Hope it's not bricked !!!
I use the CSW 2.5 on my test rig and have recently updated to the 454 without problems,
in the readme I saw that there was no update for the CSW 2.5 hardware
Base FW 693
Motor FW 22