Fanatec CSL McLaren GT3 Wheel with QR2
Jens Janssen
Member
Hello.
I have the new ClubSport DD+ and have converted my McLaren Wheel to QR2. But the Fanatec Control Center software only shows me a maximum of 8 Nm. Why ? I can't change anything. The wheel can also handle the full Nm on a Podium DD1 or DD2 with the QR1. I want to enjoy the full 15 Nm! :-( firmware and drivers are up to date.
Comments
I seen a YouTuber mention in his comments only the extreme wheel gets the full 15nm but all other wheels with qr2 are set to 8nm on gt7. This can’t be right
All depends on which QR2 you bought.
If it's QR2 lite it will stay at 8Nm. You need the normal QR2 or QR2 Pro.
If you don't use the QR2 Lite, but have on of the metal ones, make sure the switch under de QR is not stuck in your wheel. A switch is used to detect if it's a lite QR or a metal one.
I’ll find out in a few days when my dd+ arrives.
I have McLaren wheel & qr2 standard metal on it
I don't have the lite installed. I didn't see a pin when switching from QR1 lite to QR2. I'll check again.
Why ??
perhaps the button what checks that get stuck inside steering wheel, there was somewhere at youtube that exact same thing happened
this push the button down inside steering wheel but if that button what is inside steering wheel gets stuck. it will stay at lite mode
Hi Jens,
I was facing the same issue. I have removed the spring in the wheel as described in the following video because I don‘t need the low torque mode and now everything is fine: https://youtu.be/mPH0dkCNVWs?si=PwtQiJPqgWUDtQIO