V3 Brake Pedal Provides No Input
Mason Hart
Member
Hi, I just finished assembling my racing rig a few days ago and notice that I needed to update my firmware. After updating the firmware for DD2, DD2 motor, Formula 2.5 (pc version), and driver that everything was running smooth. That was until today when I updated my pedal driver for my Clubsport V3 pedals to version 1.35. Is anybody experiencing a similar issue. I've tried redownloading the drive from scratch, flash the pedal firmware multiple times, and checked the physical connections. I've heard stories of the loadcell sensor failing, but that still seems to give an inaccurate response in Fanatec Device Manager, whereas I'm receiving no data from the brake pedal. Clutch and Throttle are both working properly. Any thoughts/suggestions would be appreciated. Thank you
Comments
Hello. Did you connect the pedals via USB to the PC and also via RJ12 to the base?
Do not connect both at the same time. Try turning pedal auto cal on and then off, or the other way if you have it set in the driver as that can clear some weird behavior
I had when I originally set up the wheel base and pedals, but disconnected the RJ45 connector before attempting the 456 and 457 drivers.
Connecting both at the same time can brick the pedals