DD2 & Formula V2.5 with APM | No input when wheel is turned angles -20* to -60*

pawelinho71@gmail.com[email protected] Member
in Wheel Bases (and Racing Wheels)

So I've been struggling with the missshifts in a particular range of angles -20* to -58*, started a couple months ago only with the right shifter now also with the left and fisrtly it was 1 to 200 shifts, tday its consitently not shifting...

I have a :

  • Podium DD2
  • Formula V2.5 w/APM
  • QR2


I've found threads mentioning this is a software issue. Ithan had:


Driver 462 (same problem occured on 455 so I tried the update)

Wheel Base: 3.0.4.3

Wheel Base Motor 3.0.0.2

Steering Wheel: 47

QR: 7


Ive than downgraded to 429 as advised by many, than went through 439, 447, 455 - no luck, shifting was still not working in these angles...


No shifters/buttons work when wheel is turned counterclockwise -20 to -60 degrees as shown in Fanatec Control Panel.


I tried screwing the bolts on the wheel, cleaning the APM cables and plugging them back in. Unscrewed the QR2 base side.


Do you guys have any other suggestions?

Comments

  • Allan LehtlaAllan Lehtla Member
    edited October 19

    if it started happen out off nowhere it could be Formula V2.5 issue self.

    other people what talked, for them going back to the 455 fixed miss shift, but they not talk nothing about the spesific angle issue

  • pawelinho71@gmail.com[email protected] Member

    Thanks!


    Ive acutally thaken the qr2 out of the "shaft tube" had the wires connected and rotated the "tube" the wheel works but again no signal meening no button control in a specific 40* angle range.


    Maybe this is a hardware issue with the Wireless QR inside the dd2?

  • Allan LehtlaAllan Lehtla Member

    when you buy your Formula V2.5 ?

Sign In or Register to comment.