[RESOLVED] Can't set negative DRI values on my CSL Elite PS4

Nick Sotiriadis

Hello,

Except once, I am unable to use negative DRI values on my CSL Elite PS4 + PS4 wheel. I know I should be able to, even Fanatec's own posts here for recommended game settings have negative values for DRI.

I only saw negative DRI values just once, but can't recall in which system (pc or ps4) or in which mode but haven't been able to reproduce. Are there any specific cases where DRI values are simply not allowed? Does it have to do with the initial calibration of the wheel? Does it have to be connected to a usb port when turning on, specific mode or anything?

Looking forward for responses! Thanks!

Maurice Böschen

Install the newest driver 335 and flash the wheel base and motor firmware.

Nick Sotiriadis

Well, where are these drivers? On website up to v328 available.

Also I am a bit confused with the drivers-firmware combo. Does each driver come with its respective firmware or can you try different combinations between the two?

Is there any changelog/roadmap of drivers/firmware versions?

Gonzalo Garcia Aguilar

Nick Sotiriadis said:

Well, where are these drivers? On website up to v328 available.

Also I am a bit confused with the drivers-firmware combo. Does each driver come with its respective firmware or can you try different combinations between the two?

Is there any changelog/roadmap of drivers/firmware versions?

https://www.fanatec.com/forum/discussion/628/fanatec-beta-driver-v330-for-csl-and-csw-bases-all-wheels/p3