CS DD Wheelcalibration after PowerOn
To all the CS DD Users who actually have there base in use:
When you start the Base how dose the wheel calibration looks like?
Befor i got the CS DD i´ve used a CSW 2.5 and when i´ve started these base, the Wheel calibrates by moving completly to the right, then completly to the left and then centers in middle position.
My CS DD now just moves randomly to the right ( somtimes just half a round, somtimes one an a half) an then the wheel stops in a random position.
The wheelbas works, so actually everything is fine, i´m just wondering about these for me strang way of wheel calibration.
Comments
The current firmware of the CS DD has an issue where the axis does not return back to center position after calibration.
On DD bases two scenarios are possible: 1st scenario is the axis moves around 60° to the right and then back to center. 2nd scenario is the axis makes a full 360° rotation and then stops at the center position. Both scenarios are fine and they depend on where the position sensor is mounted which is different for every base.
Due to the current FW issue the axis atm stops at random positions after it found the position sensor. This will be fixed with the next firmware where the axis will return back to center position properly.
Thanks Maurice for the quick reply!
Thats the answer i wanted to hear 😊
So for now just enjoing the new base an waiting for the next driverupdate to fix these "issue".
Good morning my csl dd does 5 degrees to the left then 30 degrees to the right and returns to the central position slightly offset. is this a normal calibration?
Yes
👍