CSL DD no full nm with boost kit
Hey guys! Can you please help me. I have the CSL DD wheelbase with the 8nm boostkit installed and CSL Elite Mclaren v2 Steering Wheel with QR1 Aluminum Release. But for some strange reason when i look into the Fanatec Control Panel Software and i put the Force Feedback to 100% it only just shows 4nm of torque. Boost kit is detected from the software. The Logo is in the under right corner. Without the boost kit i also only have 3nm torque instead of 5nm. All Drivers are on the latest firmware. What could be the issue here.
Comments
Most likely you use a FOR value of 50?
FFB, FFS and FOR all have direct influence on the Nm as explained in the mouse hover tooltip which shows when you hover over the Nm value.
Ok. I will try to increase the FOR value and look if the nm increase as well. Thx.