CSL Load Cell cannot reach 100% Input with BRF 100% after Firmware 1.8 update
Marc Bakuniec
Member
in Pedals
I'm running driver 457 and had never updated the Load Cell Firmware (was 1.6) and didn't have any problems. I could set BRF to 100% and reach 100% Brake Input in the Fanatec Control Panel.
Yesterday I updated the Firmware to 1.8 and now with BRF set to 100% I can only reach about 50% Brake force pressing as hard as I can. Therefore I have to set BRF to 30% to be able to reach 100% in the Control Panel. I use 3D Rap BTW so my pedal travels further and is easier to press, so I should easily be able to reach 100% like it was before the firmware update.
Although the end result is kind of similar it still doesn't seem like this is the way it should be, anyone have an explanation/ the same behaviour?
Comments
you not get any benefit by update the pedals. its a you who are press the pedals, fanatec pedal update not makes you faster at all
Yeah I guess like always don't upgrade if there are no problems. I manually went back to firmware 1.6 and things are back to normal.
Still weird though
firmware bugs
You know a loadcell is based on pressure, not travel, right?