DD+ only 12NM
Hi all, can anybody answer me why my DD+ is now only able to go to 12NM in fanalab and fanatec control panel.
I never run it at full power but its a bit annoying paying extra for the DD+ for the same as the standard DD.
Hi all, can anybody answer me why my DD+ is now only able to go to 12NM in fanalab and fanatec control panel.
I never run it at full power but its a bit annoying paying extra for the DD+ for the same as the standard DD.
Comments
perhaps a bug
DD+ should go 15 nm
or someone send you DD instead off DD+
It was at 15nm but for some reason its now only going to 12nm
Hi check the sliders in Fanatec control APP or Fanalab there is one for FFB level make sure it is at 100 %
.
Does DD+ still have Peak/Linear option? Linear mode will reduce your ffb.
you using 457 drivers in PC mode? i think someone comment about this that he have weaker nm and 455 drivers help for him with latest frimware
Mine is stuck at 15nm no matter where I set it in the Fanatec CP. I think it's just a bug in CP. Not the actual force, just that the line in code is not updating to show the difference after you change it. One day it was 8nm and not moving. So I wouldn't worry about it.