Torque Magnitude Issue
Hello, I have a Fanatec Podium DD2 wheel base and a ClubSport Universal Hub V2 wheel attached to it. I have a simple test to verify the system where I output torque as a percentage of SWA. a 60deg SWA would output 6 as output torque. However it doesn't feel like a 6Nm torque. Feels almost half of it. I believe the base outputs torque in Nm. Is that correct or is a menu where I need to set the output torque units. I do have force feedback set to 100.
Comments
directX can control the strength as well, how exactly you measure the Nm ?
I can tell you this that DD2 is strong en-oh for hurt you, there are in market also 35 Nm ones if you want end in hospital
I am not sure how to measure it. It would be useful if the base displays the torque coming out. I wrote a C program that takes in the SWA multiplies it by 0.1 and returns that as the torque. So for a SWA of 60deg I should see a 6Nm torque coming out to the wheel. But it doesn't feel like 6Nm.
you mean this stuff comes out off base?
Yes. How do I display those menus? The display has the Fanatec logo. When I press it it goes into the calibration menu
you need press and hold the Tuning Menu and same time use the FunkySwitch
Thank you. I was able to find the torque menu. Do you know what FFB Set Point is?
Also, has anyone verified if the torque displayed in the Motor Data Analysis is accurate?
no. i not seen yet info about this if it is actually accurate