Unspecified error when trying to flash firmware to Fv2 Wheel and QR2
Dan Lee
Member
Trying to update Formula V2 - says to install WQR firmware I need to detach the wheel,. which I do, I get a validating firmware message and then Waiting for response, which fails.
Very annoying and Im stuck on the old firmware which is a beta
Comments
you need always remove the steering wheel when you need todo the WQR install
after when that WQR install is done correctly, you can todo the steering wheel updates
Thats my point, I remove the wheel and get the "unspecified error"
Look at the screenshot, I remove the wheel and the error occurs. The only way back is to reinstall the entire driver.
you need install WQR first
your image i see only that you already connected the steering wheel without even install the WQR
It does that first and fails everytime. How do I just do that one ? I try manual and I get the same error.
I advise you not to update, with the new firmware it gives problems during gear shift, 0.3.5.0 is stable
https://forum.fanatec.com/discussion/36707/formula-v2-5x-shifters-not-working
Wow
I've got 2 tickets open and nobody at Fanatec has responded at all. I can't update the firmware anyway even if I wanted to. :/
do not connect steering wheel till you see that WQR is installed successfully with correct WQR version number
you may need todo also base restart if it fails or something
0.0.0.0 shows that something go wrong and you may need try again
It fails every time, WQR just will not update. I get the message unspecified error.
I detach the wheel with the QR2 attached to the wheel and not the wheel base and it always gives me the error.
Hi Dan,
had the same issue with the 464 driver package.
Used the 455 driver package to update the WQR to 1.0.0.3
Afer that I used the 464 driver package to update the WQR to 1.1.0.3
Maybe this helps.
Best regards, Jan