Can't accept Torque Key warning message DD2
I have a Podium DD2 base, and am using a Formula V2 wheel on my XBOX One.
When I turn on the base, it gives me the warning for the Torque key, since it is installed...but the steering wheel will not allow me to accept it?
I've read that if you turn the wheel to 90 degrees for 5 seconds, it should accept as well, but I couldn't get that to work either.
Help!
Comments
Are you pressing A button (button2) on the wheel? Is it in Xbox mode? If so, try starting the wheel without it plugged into the Xbox and enable HT mode.
Yes, A (button 2).
It is in Xbox mode.
I will try starting the base, then installing the torque key after it starts up.
Leave the Torque key in, start the base, enable HT, plug into the Xbox. You shouldn't need to do this normally.
Ok, I'll give it a go. Thanks!
I have the same Problem since today.
Podium Wheelbase DD1 PS4
Clubsport Steering Wheel RS
Driver latest
Firmware lastest
My Formula Wheel works fine....
any help? :(
thx