Universal Hub, loosen screws
Tiku Taku Iines ja Aku
Member
That problem was since day 1 (Apr 6 2020).
Rattle noise...I thought it comes from quick release but it wasn´t.
All of those six screws inside Hub was loosen.
Tighten and now it´s totally silence 🤗
I hope opening it did not affect to warranty 😯
Other option would be send it back to Fanatec.
Only problem was 4 screws of circuit board, those were very tight!
Comments
Opening the HUB does not void your warranty.
I suppose so, there is instructions at manual how to open it and tune button modules.
Circuit board is only with 4 screws and then slide few mm to usb port direction and gently pull it up. Under board you found those 6 screws to tighten.
Actually there is instruction at DD1 manual how to change quick release...so maby you don´t brake warranty if you do some repairs by yourself...that´s easier/cheaper also for Fanatec support if customer is capable to DIY.
I think you may have saved me with this post. I have an R300 bolted to a Universal Hub and it creaks like crazy. I thought I had checked every bolt, but did not know there were six under the PCB.
Thanks!