Can't change the ACP
Erik Nerger
Member
For a couple of weeks now I can't change the ACP setting anymore. It is automatically set to Brake / Throttle and not possible to change. I really have no Idea what to do anymore.
Comments
More Info...
Which wheel?
Which Base?
Which Driver?
Which firmware?
And no matter in which position the middle MPS of the wheel is, it's always brake/throttle and does not change? Because only that MPS controls the ACP mode and it's not possible to adjust ACP in the Software for this wheel.
Then I would assume that the middle MPS is broken and you should contact the support.
In the Control Panel the options on the ACP are just grey and I can't click on anything.
in FanaLab It's not grey but it still doesn't let me click on anything.
I can switch between every MPS but that does not have any effect.
That's how it looks in the Control Panel.
I already thought you mean exactly that.
This is intended and NO issue.
As I explained in my initial answer the ACP mode is controlled by the middle MPS exclusively.
ACP on a Formula v2 or McLaren wheel can NOT be changed in either the Driver UI or FanaLab (in BOTH its greyed out for a reason!).
So just turn your middle MPS from Position C (brake/throttle) to A (Clutch Bite Point), B (Clutch/Handbrake) or D (Mappable Analogue Axes) to enable the desired ACP mode you want.
For reference, its this MPS knob which controls the ACP mode exclusively:
If the ACP mode is still stuck at brake/throttle when you turn that MPS knob to Position A, B or D then that knob is broken and you have to contact the support.
Ohh. I understand now, Thank you.