DD1 nm using linear without torque inserted
Dean Swain
Member
Can someone from Fanatec give the exact figure for this combination for the DD1, I dont require advise on why or why not to use the torque key I would just like the output in nm, is this possible because I cant that figure anywhere apart from it may be X figure no concrete number?
Thanks
Comments
15Nm when using FFB 100 in the Tuning Menu with FFS set to Linear.
Without the torque inserted?
Ah okay withOUT the Torque Key. Thats 8Nm, no matter if Linear or Peak as FFS was never working in Low Torque Mode and is therefore now also fully disabled in Low Torque Mode with most recent Firmware anyway.
Good to know thanks very much for the quick response.