Universal hub V2 (PC), buttons all over place in Fanatec software

I just got my universal hub today, and noticed almost every assignment is skewed in the software. No buttons coincide and they are all over the place. Firmware tab says I'm up to date.

Not only are the button which I'm pressing displayed at an entirely different button cluster in the test, but inside the software it doesn't even coincide with the top buttons neither (they are supposed to be one on one).

I didn't change the layout of the button clusters after receiving the hub, just installed it as is. Here's me pressing the X button on the lower left side:

I went and googled it and apparently this has been an issue for years?


Please advice Fanatec.


Sign In or Register to comment.