DD1 high torque confirmation window
i had an issue midrace where my DD1 disconnected shortly. Normally its not a big thing since those disconnects are rare and i can just continue. But this time when the disconnect happened the wheelbase wanted me to confirm the high torque mode again so i was left without ffb. In my case i have to turn my wheel 90° to the right for three seconds to confirm because im not using a fanatec wheel and since i dont see the little dash because of my monitor i was screwed. Now my question.
Is it possible to turn on the wheelbase without having to confirm high torque mode? Basically removing the little note at the beginning.
From my point of view having the torque key inserted should be confirmation enough and i think this could solve my problem.
Thanks in advance.