Brand New Shifter not detecting H-pattern
Hey guys, I finally was to finish my rig this afternoon. I was so excited to get started. Got everything calibrated, did some tuning in AC and was having a great time. I noticed that when I launched the Fanatec Control Panel that pretty much all my hardware needed a firmware update. I proceeded.
After everything was finished I jumped right back into AC but this time the H-pattern wasn't working. I switched to the sequential shifter and everything seemed to be working fine. I jumped back into the Fanatec Control Panel and everything was detecting besides the H-pattern.
I deleted the Fanatec drivers, Fanalab and Fanatec Control Panel and started over with everything. Same, thing as before, everything was being detected besides the H-pattern. I've tried to calibrate the shifter but no luck.
Is anything else I could try? I might of gotten about 25 mins in the shifter in H-pattern before I updated the firmware.
PC Driver v415
Wheel BaseFirmware v22.214.171.124
Wheel Base Motor Firmware v126.96.36.199
Podumiu Hub - Firmware v6
Wireless Quick Release - Firmware v188.8.131.52
CS Pedals v3 - Firmware v1.32
Any help would be greatly appreciated. I want to give this a shot before contacting support. Thanks