CSP v1 + CSL Elite base, no BLI setting available
Rafal Chvoinicki
Member
in Pedals
Hi everyone,
I've connected CSP v1 pedals to my CSL elite base using the adapter cable and while the pedals themself work just fine, i don't have an option to use the vibration motor that is located on the brake pedal. When i go into settings on my wheel i don't have BLI option at all (checked advanced settings).
All the devices where connected to PC to make sure they have the latest firmware version. i tried connecting CSP to PC using USB and i am able to test the vibration motor.
Does anyone have any tips on how to solve this issue?
Comments
AFAIK the CSP v1 are too old and do not support the BLI feature. You can only control the vibration via the small knob on the pedals itself, not through software.
the small knob on the pedals is for brake sensitivity, not the vibration motor
Ah remembered wrong then regarding the knob.
However, BLI is only available for CSP V3 as only the v3 can be recognized by the Software as load Cell pedals, the CSP V1 and V2 can not be detected by the Software and therefore the user has to choose the correct image in the Control Panel for these pedals so BLI can not be made available for these pedals
So the V2 also dont support BLI, do i undertand that correctly?
Yes.
ok, i think i found a thread https://forum.fanatec.com/discussion/26903/clubsport-pedals-v2-vibration. they say you can downgrade to 1) Fanatec driver 447 2) Fanalab version 1.62.3 and them vibration should work. i might try this to see if this works.
In general, it's quite strange to leave some features unavailable in the latest drivers.
ok, so i installed Fanalab version 1.62.3 and i can adjust BFI through fanalab even-though BFI is not shown in my build in wheel settings. I guess the older version of Fanalab exposes the hidden settings. And it works, after setting BFI at 60, my brake pedal vibrates when it exceeds 60%.